xUV General
Repeater Function A repeater function can be used to extend the range of ILLUMRA devices up to 2 "hops" away. For example: a switch transmits to...
Wed, 31 May, 2023 at 3:26 PM
Applies to part number: E9X-RUV, E9X-DUV-..., To restore factory default settings for any reason, use the following sequence: Activate "Advan...
Fri, 10 Feb, 2023 at 2:46 PM
Firmware version 4.2.2.x: Invert output may be turned on inadvertently by the Scan & Link Gateway. Affects: DUV, DUV-FX, RUV products. There are two w...
Wed, 19 Apr, 2017 at 7:03 PM
The ILLUMRA xUV products are compatible with 100-277 VAC supply. A step-down transformer may be used to drop the voltage from 480 or 347VAC to a voltage in ...
Tue, 19 Sep, 2017 at 7:07 PM
1: Hold Menu button for 5 seconds, until relay begins to click, then release the button. If a load is connected it will begin to cycle on and off. 2. Tripl...
Tue, 12 Mar, 2019 at 7:46 PM
Manual-On / Auto-Off (Vacancy mode) is the default operating mode when using a motion sensor with ILLUMRA line voltage controllers. When linked in the basic...
Mon, 8 May, 2023 at 1:05 PM
To decide which controller is best suited for the application there are a couple factors to consider. What is the total amperage of the circuit? What is...
Wed, 11 Jan, 2023 at 4:02 PM
Applies to: E9X-DUV..., E9X-RUV... Overview The output state of a controller upon Power Up (when power is removed and restored) may be configured to be...
Mon, 13 Feb, 2023 at 6:32 PM